Environmental Testing Equipment
Temp Test Chamber/Uses:
This machine offers a hot and humid environment to compare rubber, plastic material tested before and after the change and the degree of decline less strongly ; This machine can simulate the container environment , to detect rubber, plastic at high temperature and humidity , fading, shrinkage circumstances, the machine specifically test a variety of materials , heat, cold , moisture performance.
1.Temperature uniformity : ± 1.5 ℃
2.Humidity range : 20% ~ 98% RH
3.Humidity fluctuation : ± 2% RH [sales(at)aslitesting.com]
4.Humidity Uniformity : ± 3% RH
5.Warm-up time : Average 3 ℃ per minute ( nonlinear load )
6.Cooling time : an average of 1 ℃ per minute ( nonlinear load )
7.Inside and outside the box material : stainless steel
Temp Test Chamber/Controller:
1.Korea TEMI880 color touch screen programmable temperature and humidity controller (English translation)
2.Korea TEMI300 button programmable temperature and humidity control film ( English display )
3.Protection: compressor overheating, over-current, over-pressure , heated humidified air burning from the inside temperature , water alarm system
4.Standard configuration: observation window ( double hollow glass ) one ; ф50mm test hole ( in the left with ) a ; sample holder sets ( height adjustable ) .
5.inside lights ( fluorescent ) a ; mobile working round four ; humidifier tank one ; communication interface ; connected to a computer operating software, temperature and humidity .
6.balanced thermostat humidity (BTHC) control system working environment : +5 ℃ ~ +35 ℃ Heater: Nichrome heating wire heater humidifier : evaporative surface .
Humidity Testing Equipment/Device structure
1.chamber box for the overall form of the structure , the cooling system is located in the lower part of the cabinet , the control system is located in the upper part of the chamber .
2.the end of the duct mezzanine studio , distribution heaters , refrigeration evaporator, fan and other devices ; left side of the chamber has Ф50 cable hole , single- chamber door ( stainless steel door handle embedded )
3.the use of double high-temperature aging silicone rubber seal , which can effectively guarantee the drain chamber temperature
4.with observation windows , anti-frost device and can control lights switch on the door . Multi-layer hollow glass observation window , glue chip inside the conductive film is heated defrost . Philips Lighting lamps imported brands , which can effectively test the full range of observed changes in the working chamber .